Camber, Caster And Kingpin Inclination: Caster
WARNING: This page is about a different variant/trim than selected.
Standard value:
4°25' ± 0°30' (Left/right deviation within 0°30')
Kingpin inclination 13°50' ± 1°30'
NOTE:
Camber and caster are preset at the factory and cannot be adjusted.
CAUTION:
Do not apply the vehicle weight to the wheel bearing with the driveshaft nut loosened.
NOTE:
Tighten the wheel alignment gauge attachment (special tool: MB991004) to the specified torque, then perform measurement.
Tightening torque: 144 - 176 N.m (106 - 130 ft-lb)