LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Twin Clutch-SPORTRONIC Shift Transmission On-Vehicle Service & Diagnosis -- Lancer) >> Twin Clutch SST Control Mode Switch >> Inspection >> Twin Clutch SST Control Mode Switch Check

Twin Clutch SST Control Mode Switch Check

WARNING: This page is about a different variant/trim than selected.
  1. Check the continuity between the connector terminals of twin clutch SST control mode switch.
    CONTINUITY SPECIFICATION

    Terminal number Switch position Continuity
    2 - 3 Operate to direction A, then hold. Yes (2 Ω or less)
    Other than above Not present
    1 - 3 Operate to direction B, then hold. Yes (2 Ω or less)
    Other than above Not present
    Fig 1: Checking Continuity Between Connector Terminals Of Twin Clutch SST Control Mode Switch
    G06679225Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. When other than above, replace the twin clutch SST control mode switch.
scientia non olet · About LEMON Manuals