Electric Pump Relay Check

WARNING: This page is about a different variant/trim than selected.

Using a jumper wire, connect the positive battery terminal (+) to the electric pump relay terminal No. 3, and the negative battery terminal (-) to the terminal No. 1.

Check for continuity between the electric pump relay terminals No. 2 and No. 4.

CONTINUITY SPECIFICATION

Jumper wire	Continuity between terminals No. 2 and No. 4
Connect	Yes (2 Ω or less)
Disconnect	No

If defective, replace the electric pump relay.

Fig 1: Checking Continuity Between Electric Pump Relay Terminals No. 2 And No. 4
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.