>>A<< Manual Control Shaft/Plug/Bolt Installation Caution

When installing bolt, use magnetic tools to prevent them from falling out.

1. Install the manual control shaft carefully and tighten the bolt to the specified torque.

   Tightening torque: 10 ± 1.5 N.m (89 ± 8 in-lb) 

   Fig 1: Identifying Bolt

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Tighten the plug to the specified torque.

   Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

   Fig 2: Identifying Plug

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.