LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Rear Suspension & Wheel Alignment - Lancer Evolution) >> Trailing Arm >> Removal And Installation >> Installation Service Point >> >>A<< Self-Locking Nut Installation

>>A<< Self-Locking Nut Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using a transmission jack and wooden block as shown in the illustration, raise the trailing arm assembly.
  2. Install the self-locking nut and tighten it to the specified torque.

    Tightening torque: 81 ± 6 N.m (60 ± 4 ft-lb) 

    Fig 1: Raising Trailing Arm Assembly Using Transmission Jack And Wooden Block
    G05394520Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals