LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Rear Suspension & Wheel Alignment - Lancer Evolution) >> Shock Absorber Assembly >> Removal And Installation >> Notes

Removal And Installation: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • The part indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.
  • The part indicated by *1 is the nut and nut with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
    Fig 1: Shock Absorber Assembly Replacement Components With Torque Specifications
    G06677626Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals