LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Rear Suspension & Wheel Alignment - Lancer Evolution) >> Rear Suspension Diagnosis >> Symptom Procedures >> INSPECTION PROCEDURE 3: Body Tilting >> Diagnosis

INSPECTION PROCEDURE 3: Body Tilting: Diagnosis

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. Check for weak or deteriorated bushings. 

    Q: Are the bushings in good condition? 

    • YES:  Go to Step 2.
    • NO:  Replace the faulty part, and then go to Step  5.
  2. STEP 2. Check for weak or broken coil springs. 

    Q: Are the coil springs in good condition? 

    • YES:  Go to Step 3.
    • NO:  Replace the faulty part, and then go to Step  5.
  3. STEP 3. Check the upper arms and/or lower arms and/or control links for deformity or damage. 

    Q: Are the upper arms and/or lower arms and/or control links deformed or damaged? 

    • YES:  Replace the faulty part, and then go to Step  5.
    • NO:  Go to Step 4.
  4. STEP 4. Check the trailing arms for deformity or damage. 

    Q: Are the trailing arms deformed or damaged? 

    • YES:  Replace the faulty part, and then go to Step 5.
    • NO:  Go to Step 5.
  5. STEP 5. Retest the system. 

    Q: Is the malfunction eliminated? 

    • YES:  The procedure is complete.
    • NO:  Return to Step  1.
scientia non olet · About LEMON Manuals