LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Rear Suspension & Wheel Alignment - Lancer Evolution) >> Rear Suspension CROSSMEMBER >> Removal And Installation >> Notes

Removal And Installation: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.
  • The parts indicated by *2 are the bolts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
    Fig 1: Rear Suspension Crossmember Replacement Components With Torque Specifications
    G06677640Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals