LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Twin Clutch-SPORTRONIC Shift Transmission Overhaul -- Lancer Evolution) >> Transfer >> Disassembly And Assembly >> Assembly Service Point >> >>A<< Cover Installation

>>A<< Cover Installation

WARNING: This page is about a different variant/trim than selected.
  1. Completely degrease the FIPG-applied surface so that water and oil including the old sealant cannot adhere to the surface coated with the sealant.

    Never touch the degreased surface by hand.

  2. Apply a 1.5 mm (0.06 in) diameter bead of sealant as illustrated onto the cover.

    Specified sealant: Mitsubishi Part No. MD997740 or equivalent 

  3. Attach the cover to the transfer and tighten it to the specified torque.
    Fig 1: Applying Bead Of Sealant Onto Cover
    G05903888Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals