LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Twin Clutch-SPORTRONIC Shift Transmission Overhaul -- Lancer Evolution) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>G<< Seal Cover Bracket And Seal Cover Installation

>>G<< Seal Cover Bracket And Seal Cover Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the seal cover to the special tool MB992324 and MB992325.
    Fig 1: Installing Seal Cover To Special Tool MB992324 And MB992325
    G06471560Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Remove the special tool MB992324 from MB992325.
    Fig 2: Identifying Special Tool MB992325
    G06471561Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install the seal cover to the transaxle case. Remove the special tool MB992325.
    Fig 3: Identifying Special Tool MB992325
    G06471562Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Use special tool MB992323 to install the seal cover to the transaxle.
    Fig 4: Installing Seal Cover To Transaxle Use Special Tool MB992323
    G06471563Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the seal cover bracket.

    Confirm that it is not shaky.

  6. Tighten the seal cover bracket mounting bolt to the specified torque.

    Tightening torque: 10 ± 1 N.m (89 ± 8 in-lb) 

    Fig 5: Identifying Seal Cover Bracket
    G06471564Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals