LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Twin Clutch-SPORTRONIC Shift Transmission Overhaul -- Lancer Evolution) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>C<< Oil Pan Assembly Installation

>>C<< Oil Pan Assembly Installation

WARNING: This page is about a different variant/trim than selected.
  1. Completely degrease the oil pan assembly installation surface on the transaxle side.
  2. Remove the gasket from the oil pan assembly, and completely degrease the groove of the oil pan assembly (gasket installation area) and the gasket. Then, install the gasket to the groove of the oil pan assembly.
    CAUTION: When installing the oil pan assembly, pay attention to avoid damage to the connector and the O-ring installed to the connector.
  3. Tighten the screws to the specified torque in the order shown in the illustration.

    Tightening torque: 10 ± 1 N.m (89 ± 8 in-lb) 

    Fig 1: Identifying Oil Pan Assembly Bolts Tightening Sequence
    G06471482Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals