LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Twin Clutch-SPORTRONIC Shift Transmission Overhaul -- Lancer Evolution) >> Sealants And Adhesives >> Form-In-Place Gasket (FIPG) >> Surface Preparation

Surface Preparation

WARNING: This page is about a different variant/trim than selected.

Thoroughly remove all substances deposited on the FIPG application surface, using a gasket scraper.

Make sure that the FIPG application surfaces is flat and smooth. Also make sure that the surface is free from oils, greases and foreign substances. Do not fail to remove old FIPG that may remain in the fastener fitting holes.

scientia non olet · About LEMON Manuals