Fastener Tightening Specification: Transaxle
WARNING: This page is about a different variant/trim than selected.
TRANSAXLE FASTENER TIGHTENING SPECIFICATION
| Item | Specification |
|---|---|
| Oil filter bracket | 10 ± 1.5 N.m (89 ± 8 in-lb) |
| Oil filter case assembly | 15 ± 2 N.m (11 ± 1 ft-lb) |
| Manual control shaft mounting screw | 10 ± 1.5 N.m (89 ± 8 in-lb) |
| Plug | 32 ± 2 N.m (24 ± 1 ft-lb) |
| Mechatronic assembly mounting bolt | 5.0 ± 1.0 → 10 ± 1.5 N.m (44 ± 8 → 89 ± 8 in-lb) |
| Mechatronic assembly (The connector part) mounting screw | 6.0 ± 1.0 N.m (53 ± 8 in-lb) |
| Oil pan mounting screw | 10 ± 1 N.m (89 ± 8 in-lb) |
| Clutch assembly | 7.5 ± 1.0 N.m (66 ± 8 in-lb) |
| Seal cover bracket mounting screw | 10 ± 1 N.m (89 ± 8 in-lb) |
| Control cable bracket | 11 ± 3 N.m (97 ± 26 in-lb) |
| Harness bracket | 25 ± 4 N.m (18 ± 2 ft-lb) |