LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Parking Brakes -- Lancer Evolution) >> On-Vehicle Service >> Parking Brake Switch Check

Parking Brake Switch Check

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
  1. Remove the floor console assembly (Refer to FLOOR CONSOLE ).
  2. Check for continuity between the parking brake switch terminal and the switch mounting bolt.
    CONTINUITY SPECIFICATION

    Check condition Normal condition
    When parking brake lever is pulled. Continuity exists (2 Ω or less)
    When parking brake lever is released. No continuity
    Fig 1: Checking Continuity Between Parking Brake Switch Terminal And Switch Mounting Bolt
    G05376450Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. After the check, install the floor console assembly. (Refer to FLOOR CONSOLE .)
scientia non olet · About LEMON Manuals