>>A<< Piston Cup/Piston Installation

WARNING: This page is about a different variant/trim than selected.

Apply brake fluid to the entire inner surface of the release cylinder.
Specified brake fluid: Brake fluid DOT 3 or DOT 4

Fig 1: Applying Brake Fluid To Entire Inner Surface Of Release Cylinder
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply grease to the piston and piston cups and insert the piston assembly into the release cylinder.
Specified grease: Rubber grease

Fig 2: Applying Grease To Piston And Piston Cups
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.