LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (Fuel Supply System - Lancer Evolution) >> Fuel Tank >> Removal And Installation >> Installation Service Points >> >>C<< Fuel Main Pipe Connection

>>C<< Fuel Main Pipe Connection

WARNING: This page is about a different variant/trim than selected.
  1. Before the installation, push up the retainer of the fuel main pipe.
    Fig 1: Pushing Up Retainer Of Fuel Main Pipe
    G05375328Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Connect the connector of fuel main pipe to the fuel pump module securely and push down the retainer of the connector to lock it firmly.
  3. After the installation, slightly pull the fuel main pipe to check that it is connected securely. At this time, also check that there is approximately 1 mm (0.04 inch) play.
    Fig 2: Pushing Down Retainer Of Connector To Lock It Firmly
    G05375329Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals