LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (Fuel Supply System - Lancer Evolution) >> Fuel Tank >> Disassembly And Assembly >> Disassembly Service Points >> >>C<< Hose Clamp Installation

>>C<< Hose Clamp Installation

WARNING: This page is about a different variant/trim than selected.

Connect the fuel filler hose, and tighten the bolt of hose clamp so that the bolt tightening dimension of the hose clump becomes 8.5 ± 1.5 mm (0.33 ± 0.06 inch).

Fig 1: Identifying Bolt Tightening Dimension Of Hose Clump 8.5 ± 1.5 mm (0.33 ± 0.06 inch)
G05393599Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals