LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Heating, Air Conditioning And Ventilation -- Lancer Evolution) >> Special Tools

Special Tools

WARNING: This page is about a different variant/trim than selected.
SPECIAL TOOLS REFERENCE

Tool Tool number and name Supersession Application
G04874552Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991367 Special spanner MB991367-01 Armature mounting nut of compressor removal and installation
G05386076Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991386 Pin MIT217213 Armature mounting nut of compressor removal and installation
G06679184Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991658 Test harness set Tool not available Inspection of throttle position sensor
G05384141Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991223
  1. MB991219
  2. MB991220
  3. MB991221
  4. MB991222
 Harness set
  1. Check harness
  2. LED harness
  3. LED harness adapter
  4. Probe
 Continuity check and voltage measurement at harness wire or connector
  1. For checking connector pin contact pressure
  2. For checking power supply circuit
  3. For checking power supply circuit
  4. For connecting a locally sourced tester
G06679186Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB992006 Extra fine probe General service tool Making voltage and resistance measurement during troubleshooting
G06244449Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991958
  1. MB991824
  2. MB991827
  3. MB991910
  4. MB991911
  5. MB991914
  6. MB991825
  7. MB991826

M.U.T.-III sub-assembly
  1. Vehicle communication interface (V.C.I.)
  2. M.U.T.-III USB cable
  3. M.U.T.-III main harness A (Vehicles with CAN communication system)
  4. M.U.T.-III main harness B (Vehicles without CAN communication system)
  5. M.U.T.-III main harness C (for Chrysler only)
  6. M.U.T.-III measurement adapter
  7. M.U.T.-III trigger harness
 MB991824-KIT
NOTE: G: MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.
CAUTION: M.U.T.-III main harness A (MB991910) should be used. M.U.T.-III main harness B and C should not be used for this vehicle.
DTC, data list and actuator test check.
scientia non olet · About LEMON Manuals