LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Heating, Air Conditioning And Ventilation -- Lancer Evolution) >> Compressor Assembly And Tension Pulley >> Disassembly And Assembly >> Assembly Service Points >> >>E<< Air Gap Adjustment

>>E<< Air Gap Adjustment

WARNING: This page is about a different variant/trim than selected.

Check whether or not the air gap of the clutch is within the standard value.

Standard value: 

0.3 - 0.5 mm (0.012 - 0.020 inch) 

NOTE: If there is a deviation of the air gap from the standard value, make the necessary adjustment by adjusting the number of shims.
Fig 1: Checking Air Gap
G05386108Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals