LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Clutch On-Vehicle Service -- Lancer Evolution) >> Clutch Pedal And Master Cylinder >> Removal And Installation >> Installation Service Points >> >>A<< Clutch Tube Assembly A Connection

>>A<< Clutch Tube Assembly A Connection

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When connecting the clutch tube assembly A and clutch master cylinder, check that the O-ring and clip are not damaged.
  • If any connection areas of clutch tube assembly A and clutch master cylinder or O-ring is dirty, clean with the clutch fluid.

Assemble the clip to the clutch master cylinder. Then, connect the clutch tube assembly A to the clutch master cylinder.

Fig 1: Identifying Clutch Master Cylinder, Clip And Clutch Tube Assembly
G05393842Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals