LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Clutch On-Vehicle Service -- Lancer Evolution) >> Clutch Pedal And Master Cylinder >> Inspection >> Clutch Switch Check And Adjustment

Clutch Switch Check And Adjustment

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not perform work wearing gloves which have grease on them.
  1. Connect a circuit tester (Ω range) to the clutch switch connector.
  2. When continuity does not exist with the plunger pressed from the outer case end face by the dimension shown in the illustration, and when continuity exists with the plunger released (2Ω or less), the switch is in good condition.
    Fig 1: Connecting Circuit Tester To Clutch Switch Connector
    G05393847Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals