LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Clutch On-Vehicle Service -- Lancer Evolution) >> Clutch Control >> Removal And Installation >> Installation Service Points >> >>A<< Clutch Tube Assembly Installation

>>A<< Clutch Tube Assembly Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When connecting each part, check that the O-ring and clip are not damaged.
  • If any connection area or O-ring is dirty, clean with the clutch fluid.

Assemble the clips to the clutch master cylinder and clutch tube assembly B. Then, connect the clutch tube assembly A.

Fig 1: Identifying Clutch Master Cylinder, Clip And Clutch Tube Assembly
G05393842Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 2: Identifying O-Ring, Clip And Clutch Tube
G05393851Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals