LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Continuously Variable Transaxle On-Vehicle Service -- Lancer) >> Diagnosis >> Symptom Procedures >> Inspection Procedure 3: Shock is experienced during N to D and/or N to R shifting operation >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. Engine idling speed check 

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Refer to the ENGINE DIAGNOSIS 2.0L Non Turbo, ENGINE DIAGNOSIS 2.0L Turbo for Engine troubleshooting.
  2. STEP 2. Line pressure check 

    Carry out "hydraulic test" (Refer to HYDRAULIC PRESSURE TEST  ).

    Q: Is the check result normal? 

    1. YES:  Go to Step 3.
    2. NO:  Repair according to the hydraulic pressure test diagnosis table.
  3. STEP 3. Retest the system. 
    • Replace TCM.
    • Recheck the trouble symptom.

      Q: Does the malfunction take place again? 

      1. YES:  Replace the CVT assembly.
      2. NO:  The inspection is complete.
scientia non olet · About LEMON Manuals