LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Continuously Variable Transaxle On-Vehicle Service -- Lancer) >> Diagnosis >> Symptom Procedures >> Inspection Procedure 2: Vehicle Creeps in the N Range >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. M.U.T.-III data list 

    Item 49: Transmission range switch

    Check that the service data changes when the selector lever is moved to all ranges.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Go to Step  3.
  2. STEP 2. Check of the transmission range switch and shift control cable 

    Refer to TRANSMISSION RANGE SWITCH CONTINUITY CHECK  .

    Q: Is the check result normal? 

    1. YES:  Go to Step  4.
    2. NO:  Adjust the transmission range switch and the control cable.
  3. STEP 3. Transmission range switch continuity check 

    Refer to TRANSMISSION RANGE SWITCH CONTINUITY CHECK  .

    Q: Is the check result normal? 

    1. YES:  Go to Step 4.
    2. NO:  Replace the transmission range switch.
  4. STEP 4. Retest the system. 
    • Replace TCM.
    • Recheck the trouble symptom.

      Q: Does the malfunction take place again? 

      1. YES:  Replace the CVT assembly.
      2. NO:  The inspection is complete.
scientia non olet · About LEMON Manuals