LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Continuously Variable Transaxle On-Vehicle Service -- Lancer) >> Diagnosis >> Diagnostic Trouble Code Procedures >> DTC P0868: Secondary Pressure Drop >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. Check other diagnosis codes. 

    Q: Are other diagnosis codes set? 

    1. YES:  Go to the appropriate troubleshooting.
    2. NO:  Go to Step 2.
  2. STEP 2. Check the following connector: 
    • B-08 CVT assembly connector
    • C-40 TCM connector
    • A-09 Intermediate connector

      Check contacts for internal short circuit.

      Q: Is the check result normal? 

      1. YES:  Go to Step 3.
      2. NO:  Repair the defective connector.
  3. STEP 3. Check for short to ground in the wiring harness between the TCM connector and the CVT assembly connector. 
    • Between C-40 TCM connector (terminal No. 39) and B-08 CVT assembly connector (terminal No. 7)

      OK: 100 Ω or more 

      Q: Is the check result normal? 

      1. YES:  Go to Step 4.
      2. NO:  Repair the wiring harness.
  4. STEP 4. Symptom recheck after erasing diagnosis code 

    Q: Is the check result normal? 

    1. YES:  Intermittent malfunction
    2. NO:  Replace the TCM, and then go to Step 5.
  5. STEP 5. Retest the system. 

    Q: Is the check result normal? 

    1. YES:  The procedure is complete.
    2. NO:  Replace the CVT assembly.
scientia non olet · About LEMON Manuals