LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Power Steering -- Lancer Evolution) >> Power Steering Gear Box And Linkage >> Disassembly And Assembly >> Assembly Service Point >> >>B<< Band Installation

>>B<< Band Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Secure the rack housing, and firmly crimp the bellows band by the bellows band clipping tool (special tool: MB992209).
  • Crimp the bellows band securely until the special tool (MB992209) contacts the stopper.
  1. Using the special tool (MB992209), crimp the bellows band.
    Fig 1: Crimping Bellows Band Using Special Tool (MB992209)
    G05394814Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the crimping width of the band (A) is within the range of the standard value.

    Standard value (A): 2.4 - 2.8 mm (0.09 - 0.11 in) 

    Fig 2: Checking Crimping Width Of Band Is Within Range Of Standard Value
    G05394815Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals