LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Power Steering -- Lancer Evolution) >> Power Steering Gear Box And Linkage >> Disassembly And Assembly >> Assembly Service Point >> >>A<< Tie-Rod Installation

>>A<< Tie-Rod Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not tighten the vise strongly in order not to damage the rack bar.
  1. Wrap rack bar with cloth in order not to damage, and fix the rack bar with a vise.
  2. Use special tool variable spanner (MB992249) to tighten the tie-rod to the specified torque.

    Tightening torque: 89 ± 9 N.m 

    Fig 1: Removing Tie-Rod
    G06249323Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals