Past trouble

WARNING: This page is about a different variant/trim than selected.

When the DTC No. C100A is also set, perform the diagnosis with a particular emphasis on the wiring harness and connector failures between ASC-ECU and the wheel speed sensor. For diagnosis procedures, refer to How to Treat Past Trouble ( HOW TO TREAT PAST TROUBLE ).
When DTC No. C100A is not set simultaneously, the followings can be suspected.
- Wheel(s) spinning
- Unstable vehicle attitude (spin)
- External noise interference
- Vehicle ran with the parking brake applied.
- Only two wheels are rotated on a drum tester.