LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Front Axle -- Lancer Evolution) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front caliper assembly and front disk brake, and retain the front caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY  ).
  2. Set a dial gauge as shown in the illustration. Move the hub in the axial direction and measure the end play.

    Limit: 0.05 mm (0.002 inch) 

  3. After checking, install the front brake disk and the front caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY  ).
    Fig 1: Measuring End Play While Moving Hub In Axial Direction
    G04231680Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals