LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Front Axle -- Lancer Evolution) >> Driveshaft Assembly >> Disassembly And Assembly >> Assembly Service Points >> >>C<< ETJ Boot Band (Small)/ETJ Boot Band (Large) Installation

>>C<< ETJ Boot Band (Small)/ETJ Boot Band (Large) Installation

WARNING: This page is about a different variant/trim than selected.

Adjust the distance (A shown in the illustration) between the boot bands to the standard value to adjust the air volume inside the ETJ boot to the specified value, then be sure to tighten the ETJ boot band (large) and ETJ boot band (small).

Standard value (A): 80 ± 3 mm (3.14 ± 0.12 inches) 

Fig 1: Identifying Distance Between ETJ Boot Band (Large) And ETJ Boot Band (Small)
G05376119Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals