INSPECTION PROCEDURE 6: Squealing, Groaning or Chattering Noise when Brakes are Applied: Diagnosis

WARNING: This page is about a different variant/trim than selected.

STEP 1. Check the brake disk and pads for wear or cutting.
Q: Is there wear or cutting?
- YES: Repair or replace the part. Then go to Step 4.
- NO: Go to Step 2.
STEP 2. Check the calipers for rust.
Q: Is there any rust?
- YES: Remove the rust. Then go to Step 4.
- NO: Go to Step 3.
STEP 3. Adjust the brake pedal.
Refer to BRAKE PEDAL CHECK AND ADJUSTMENT .

Q: Is the brake pedal adjusted correctly?
- YES: Go to Step 4.
- NO: Adjust the brake pedal. Then go to Step 4.
STEP 4. Recheck symptom.
Q: Is the symptom eliminated?
- YES: The procedure is complete.
- NO: Start over at step 1. If a new symptom surfaces, refer to the SYMPTOM CHART .