LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Axle -- Lancer Evolution) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the rear brake disk. (Refer to PARKING BRAKE LINING AND DRUM .)
  2. Set a dial gauge as shown in the illustration. Move the rear wheel hub assembly in the axial direction and measure the looseness.

    Limit: 0.05 mm (0.002 inch) 

  3. When the looseness exceeds the limit value, replace the rear wheel hub assembly. (Refer to REAR AXLE HUB ASSEMBLY  .)
  4. After checking, install the rear brake disk. (Refer to PARKING BRAKE LINING AND DRUM .)
    Fig 1: Checking Wheel Bearing End Play
    G06677489Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals