LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Axle -- Lancer Evolution) >> On-Vehicle Service >> Gear Oil Replacement >> Torque Transfer Mechanism Part

Torque Transfer Mechanism Part

WARNING: This page is about a different variant/trim than selected.
  1. Remove the filler plug.
  2. Remove the drain plug and drain oil.
  3. Install the drain plug, and tighten it to the specified torque (Refer to DIFFERENTIAL CARRIER ASSEMBLY  ).
  4. Fill the specified gear oil up to the bottom of the filler plug hole.

    Specified gear oil: DIAMOND ATF-SP III 

    Amount to use: 0.55 - 0.60 dm 3  (0.58 - 0.63 qt) 

    Fig 1: Locating Filler Plug And Drain Plug
    G06677483Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the filler plug, and tighten it to the specified torque (Refer to DIFFERENTIAL CARRIER ASSEMBLY  ).
scientia non olet · About LEMON Manuals