LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Axle -- Lancer Evolution) >> On-Vehicle Service >> Gear Oil Level Check >> Torque Transfer Mechanism Part

Torque Transfer Mechanism Part

WARNING: This page is about a different variant/trim than selected.
  1. Remove the filler plug.
    Fig 1: Locating Filler Plug
    G06677480Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the gear oil level is in between the upper limit (bottom of the oil filler plug hole) and the lower limit.
  3. If the gear oil level is not in between the upper limit and the lower limit, fill the specified gear oil to the bottom of the filler plug hole.

    Specified gear oil: DIAMOND ATF-SP III 

  4. Install the filler plug, and tighten it to the specified torque (Refer to DIFFERENTIAL CARRIER ASSEMBLY  ).
    Fig 2: Checking Oil Level
    G06677445Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals