LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Axle -- Lancer Evolution) >> On-Vehicle Service >> AYC Differential Carrier Oil Seal Replacement >> Torque Transfer Mechanism Part

Torque Transfer Mechanism Part

WARNING: This page is about a different variant/trim than selected.

Required Special Tools: 

  1. Remove the driveshaft. (Refer to DRIVESHAFT ASSEMBLY  .)
  2. Remove the AYC differential carrier oil seal.
  3. Use the special tools MB990938 and MB991551 to press-fit a new oil seal.
  4. Apply specified grease to the oil seal lip and driveshaft oil seal seating area.

    Specified grease: Vaseline 

    Fig 1: Identifying Grease Applying Area
    G06677493Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals