LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Axle -- Lancer Evolution) >> Driveshaft Assembly >> Removal And Installation >> Installation Service Points >> >>C<< Washer/Rear Driveshaft Nut Installation

>>C<< Washer/Rear Driveshaft Nut Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not apply the vehicle weight on the rear wheel bearing before fully tightening the rear driveshaft nut. Otherwise, the rear wheel bearing may be broken.
  1. Be sure to install the rear driveshaft washer in the illustrated direction.
  2. Using special tool MB990767, tighten the rear driveshaft nut. At this time, tighten the nut to the specified lower limit torque so that the pin hole may align with cotter pin.

    Tightening torque: 144-176 N.m (107 - 129 ft-lb) 

  3. If the pin hole does not align with the pin, tighten the driveshaft nut [less than 176 N.m (129 ft-lb)] and find the nearest hole, then fit the cotter pin.
    Fig 1: Tightening Driveshaft Nut
    G06672621Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals