LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Axle -- Lancer Evolution) >> Differential Carrier Assembly >> Disassembly And Reassembly >> Assembly Service Points >> >>B<< Oil Seal Installation

>>B<< Oil Seal Installation

WARNING: This page is about a different variant/trim than selected.
  1. Use special tool MB991245 to press-fit the oil seal.
  2. Apply multi-purpose grease to the oil seal lip and driveshaft oil seal seating area.
    Fig 1: Pressing Oil Seal
    G06677492Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals