LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Intake System And Exhaust System - Lancer Evolution) >> On-Vehicle Service >> Turbocharger Waste Gate Solenoid Check >> NO. 2 turbocharger wastegate solenoid or black connector >> B Check of coil resistance

B Check of coil resistance

WARNING: This page is about a different variant/trim than selected.
  1. Measure the resistance between the solenoid terminals.

    Standard value: 29 - 35 Ω at 20°C (68°F) 

    Fig 1: Measuring Resistance Between Solenoid Terminals
    G05393662Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals