LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Intake System And Exhaust System - Lancer Evolution) >> On-Vehicle Service >> Turbocharger Waste Gate Solenoid Check >> NO. 2 turbocharger wastegate solenoid or black connector >> A Operation check

A Operation check

WARNING: This page is about a different variant/trim than selected.
  1. Install the hand vacuum pump to the nipple "A" of solenoid.
  2. Use the jumper wire to connect the solenoid terminal with the battery terminal.
  3. Disconnecting the jumper wire at the negative (-) battery side, apply the vacuum pressure. Check the airtightness.
    JUMPER WIRE SPECIFICATION

    Jumper wire Nipple "B" state Normal state
    Connected Opened Negative pressure leaks
    Closed Negative pressure maintained
    Disconnected Opened Negative pressure maintained
    Fig 1: Identifying No. 2 Turbocharger Wastegate Solenoid
    G05393653Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Checking Turbocharger Waste Gate Solenoid
    G05393661Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals