>>A<< Air Hose/Air Pipe Installation

WARNING: This page is about a different variant/trim than selected.

Insert hose to stopper end and not overlap with stopper.
Place the hose clamp as shown in the illustration so that it does not overlap with the bulge and the stopper end. Then, set the hose clamp 5 ± 1 mm (0.20 ± 0.04 inch) away from the stopper.

Fig 1: Placing Hose Clamp
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION: Do not use an electric screwdriver or air tool. Manually tighten the hose clamp.
Align the mating marks on the air hose, air pipe, and hose clamp. Then, tighten the hose clamp to the specified torque.
Tightening torque: 6.0 ± 1.0 N.m (54 ± 8 in-lb)

Fig 2: Identifying Mating Marks On Air Hose, Air Pipe, And Hose Clamp
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.