LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Lubrication -- Lancer Evolution) >> Oil Pump Chain >> Removal And Installation >> Installation Service Points >> >>A<< Crankshaft Sprocket Installation

>>A<< Crankshaft Sprocket Installation

WARNING: This page is about a different variant/trim than selected.
  1. Wipe off the dirt on the crankshaft sprocket and crankshaft as shown in the illustration using a rag, and then degrease them.
    NOTE: Degrease them to prevent drop in the friction coefficient of the pressed area, which is caused by oil adhesion.
  2. Install the crankshaft sprocket to the crankshaft.
    Fig 1: Identifying Crankshaft Sprocket
    G05392685Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals