LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical -- Lancer Evolution) >> On-Vehicle Service >> Auto-TENSIONER Check >> Function Check >> < When using a tension gauge>

< When using a tension gauge>

WARNING: This page is about a different variant/trim than selected.
  1. Check the tension of the drive belt. (Refer to DRIVE BELT TENSION CHECK  ).
  2. Use a belt tension gauge in the middle of the belt between the pulleys shown in the illustration (at the place indicated by the arrow) to check that the belt tension is within the standard value.

    Standard value: 248 - 400 N (56 - 90 lb) 

  3. If not within the standard value, replace the auto-tensioner. (Refer to <<D>> AUTO-TENSIONER REMOVAL  ).
    Fig 1: Pulley Belt Route Diagram
    G05392357Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals