LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical -- Lancer Evolution) >> Engine Assembly >> Removal And Installation >> Installation Service Points >> >>A<< Engine Assembly/Engine Mounting Bracket Installation

>>A<< Engine Assembly/Engine Mounting Bracket Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set special tool MB991454 and a chain block to the engine assembly.
  2. Install the engine assembly, being careful not to pinch the cables, hoses or wiring harness connectors.
  3. Place a garage jack against the engine oil pan with a piece of wood in between, and install the engine mounting bracket while adjusting the position of the engine.
  4. Remove the chain block.
    Fig 1: Holding Engine Assembly With Chain Block
    G05392483Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install special tool MB991928 or MB991895 which is used during installation of transaxle assembly to hold the engine assembly. (Refer to TRANSAXLE ASSEMBLY <M/T>), (Refer to TRANSAXLE ASSEMBLY <TC-SST>)
    Fig 2: Supporting Engine Assembly
    G05392480Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 3: Supporting Engine Assembly Using Special Tool
    G05392481Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals