LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Twin Clutch-SPORTRONIC Shift Transmission On-Vehicle Service & Diagnosis -- Lancer Evolution) >> Transaxle Case Oil Seal >> Removal And Installation >> Installation Service Points >> >>C<< Transaxle Case Oil Seal (LH) Installation

>>C<< Transaxle Case Oil Seal (LH) Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply the transaxle oil to the oil seal guide (special tool: MB992311). Insert the oil seal to oil seal guide (special tool: MB992311).
    Fig 1: Inserting Oil Seal To Oil Seal Guide Special Tool MB992311
    G06471506Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Use special tool oil seal installer (special tool: MB992310) to install the oil seal to the transaxle case.
    Fig 2: Installing Oil Seal To Transaxle Case Using Special Tool MB992310
    G06677302Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals