LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Twin Clutch-SPORTRONIC Shift Transmission On-Vehicle Service & Diagnosis -- Lancer Evolution) >> Transaxle Case Oil Seal >> Removal And Installation >> Installation Service Points >> >>B<< V Ring Installation

>>B<< V Ring Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the spline with a brush or the like.
    Fig 1: Cleaning Spline With Brush
    G06471504Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Apply the transaxle oil to the V ring guide (special tool: MB992314). Insert the V ring to V ring guide (special tool: MB992314), and install the V ring to the transaxle case.
  3. Check that the V ring is installed securely.
    Fig 2: Installing V Ring To Transaxle Case Using Special Tool MB992314
    G06471570Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals