LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Supplemental Restraint System (SRS) -- Lancer Evolution) >> Seat Belts With Pre-TENSIONER >> Inspection >> Seat Belt With Pre-TENSIONER Check

Seat Belt With Pre-TENSIONER Check

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • If any component damage is found during the following inspection, replace the seat belt with pre-tensioner with a new one. Dispose of the old one according to the specified procedure (Refer to AIR BAG MODULE AND SEAT BELT PRE-TENSIONER DISPOSAL PROCEDURES  ).
  • Never attempt to measure the circuit resistance of the seat belt pre-tensioner even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental seat belt pre-tensioner operation will result in serious personal injury.
  1. Check seat belt pre-tensioner for dents, cracks or deformation.
  2. Check the connectors for damage, the terminals for deformation, and the harness for binding.
scientia non olet · About LEMON Manuals