INSPECTION PROCEDURE 2: Noise Due to Excessive Play of Wheel in Turning Direction: Diagnosis
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Check for play in the inner shaft and side gear serration, the driveshaft and side gear serration, or the driveshaft and front hub serration.
Q: Is the play found?
- YES: Replace the part. Then go to Step 2.
- NO: The procedure is complete.
- STEP 2. Retest the system.
Q: Is the abnormal noise eliminated?
- YES: The procedure is complete.
- NO: Repeat from Step 1.