<< F >> Engine Assembly Supporting

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the vacuum pipe assembly (refer to WATER HOSE AND WATER PIPE ), and install the engine hanger plate (Special tool: MB992201), then tighten the bolts to the specified torque.
Tightening torque: 11 ± 1 N.m (8 ± 1 in-lb)
< When engine hanger (special tool MB991928) is used >
1. Assemble the engine hanger (special tool MB991928). (Set following parts to the base hanger).
  - Slide bracket (HI)
  - Foot x 4 (standard) (MB991932)
  - Joint x 2 (90) (MB991930)
    
    Fig 1: Identifying Engine Hanger Plate (Special Tool: MB992201) And Thermostat Case
    Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set the feet of the special tool as shown in the figure.
  NOTE: Adjust the engine hanger balance by sliding the slide bracket (HI).
  
  Fig 2: Locating Engine Mechanical Hanger Installing Points
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Set the chain to the engine hanger plate (Special tool: MB992201) to support the engine and transaxle assembly. Remove the garage jack, and then remove the transaxle assembly upper part coupling bolts that have been loosened previously.
  
  Fig 3: Identifying Special Tools On Engine Assembly
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< Engine mechanical hanger (special tool MB991895) is used >
1. Set the feet of the engine mechanical hanger (special tool MB991895). See Fig 4.
  NOTE: Slide the front foot of the engine mechanical hanger (Special tool: MB991895) to balance the engine hanger.
  
  Fig 4: Locating Engine Mechanical Hanger Installing Points
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Set the chain to the engine hanger plate (Special tool: MB992201) to support the engine and transaxle assembly. Remove the garage jack, and then remove the transaxle assembly upper part coupling bolts that have been loosened previously.
  
  Fig 5: Identifying Engine Hanger Plate (Special Tool MB992201 And MB991895) On Engine And Transaxle Assembly
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.