Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During diagnosis, a DTC associated with other system may be set when the ignition switch is turned ON with connector(s) disconnected. On completion, confirm all systems for diagnostic trouble code(s). If diagnostic trouble code(s) are set, erase them all.
DIAGNOSTIC TROUBLE CODE CHART
| DTC No. | Diagnostic item |
|---|---|
| P0630 | VIN not recorded |
| P0701 | EEPROM system (Malfunction) |
| P0702 | Internal control module, monitoring processor system (Malfunction) |
| P0711 | TC-SST-ECU temperature sensor system (Gradient error) |
| P0712 | TC-SST-ECU temperature sensor system (Output low range out) |
| P0713 | TC-SST-ECU temperature sensor system (Output high range out) |
| P0715 | Input shaft 1 (odd number gear axle) speed sensor system (Output high range out) |
| P0716 | Input shaft 1 (odd number gear axle) speed sensor system (Poor performance) |
| P0717 | Input shaft 1 (odd number gear axle) speed sensor system (Output low range out) |
| P0725 | Engine speed signal abnormality |
| P0746 | Line pressure solenoid system (Drive current range out) |
| P0753 | Shift select solenoid 1 system (Open circuit) |
| P0758 | Shift select solenoid 2 system (Open circuit) |
| P0776 | Clutch cooling flow solenoid system (Drive current range out) |
| P0777 | Clutch cooling flow solenoid system (Stuck) |
| P0841 | Clutch 1 pressure sensor system (Poor performance) |
| P0842 | Clutch 1 pressure sensor system (Output low range out) |
| P0843 | Clutch 1 pressure sensor system (Output high range out) |
| P0846 | Clutch 2 pressure sensor system (Poor performance) |
| P0847 | Clutch 2 pressure sensor system (Output low range out) |
| P0848 | Clutch 2 pressure sensor system (Output high range out) |
| P0960 | Line pressure solenoid system (Open circuit) |
| P0961 | Line pressure solenoid system (Overcurrent) |
| P0962 | Line pressure solenoid system (Short to ground) |
| P0963 | Line pressure solenoid system (Short to power supply) |
| P0964 | Clutch cooling flow solenoid system (Open circuit) |
| P0965 | Clutch cooling flow solenoid system (Overcurrent) |
| P0966 | Clutch cooling flow solenoid system (Short to ground) |
| P0967 | Clutch cooling flow solenoid system (Short to power supply) |
| P0968 | Shift/cooling switching solenoid system (Open circuit) |
| P0970 | Shift/cooling switching solenoid system (Short to ground) |
| P0971 | Shift/cooling switching solenoid system (Short to power supply) |
| P0973 | Shift select solenoid 1 system (Short to ground) |
| P0974 | Shift select solenoid 1 system (Short to power supply) |
| P0976 | Shift select solenoid 2 system (Short to ground) |
| P0977 | Shift select solenoid 2 system (Short to power supply) |
| P1637 | EEPROM system (DTC storing malfunction) |
| P1676 | Coding incomplete |
| P1802 | Shift lever system (LIN communication malfunction) |
| P1803 | Shift lever system (CAN or LIN time-out error) |
| P1804 | Shift fork position sensor 1 and 2 system (Power supply voltage low range out) |
| P1805 | Shift fork position sensor 1 and 2 system (Power supply voltage high range out) |
| P1806 | Shift fork position sensor 3 and 4 system (Power supply voltage low range out) |
| P1807 | Shift fork position sensor 3 and 4 system (Power supply voltage high range out) |
| P1808 | TC-SST-ECU temperature, fluid temperature sensor system (Correlation error) |
| P180C | Clutch pressure cut spool sticking |
| P181B | Clutch 1 (Pressure low range out) |
| P181C | Clutch 1 (Pressure high range out) |
| P181E | Clutch 2 (Pressure low range out) |
| P181F | Clutch 2 (Pressure high range out) |
| P1820 | Shift fork position sensor 1 system (Voltage low range out) |
| P1821 | Shift fork position sensor 1 system (Voltage high range out) |
| P1822 | Shift fork position sensor 1 system (Output range out) |
| P1823 | Shift fork position sensor 1 system (Neutral) |
| P1824 | Shift fork position sensor 1 system (Poor performance) |
| P1825 | Shift fork position sensor 2 system (Voltage low range out) |
| P1826 | Shift fork position sensor 2 system (Voltage high range out) |
| P1827 | Shift fork position sensor 2 system (Output range out) |
| P1828 | Shift fork position sensor 2 system (Neutral) |
| P1829 | Shift fork position sensor 2 system (Poor performance) |
| P182A | Shift fork position sensor 3 system (Voltage low range out) |
| P182B | Shift fork position sensor 3 system (Voltage high range out) |
| P182C | Shift fork position sensor 3 system (Output range out) |
| P182D | Shift fork position sensor 3 system (Neutral) |
| P182E | Shift fork position sensor 3 system (Poor performance) |
| P1831 | Shift fork position sensor 4 system (Voltage low range out) |
| P1832 | Shift fork position sensor 4 system (Voltage high range out) |
| P1833 | Shift fork position sensor 4 system (Output range out) |
| P1834 | Shift fork position sensor 4 system (Neutral) |
| P1835 | Shift fork position sensor 4 system (Poor performance) |
| P1836 | Shift fork 1 malfunction |
| P183D | Shift fork 2 malfunction |
| P1844 | Shift fork 3 malfunction |
| P184B | Shift fork 4 malfunction |
| P1852 | Shift fork 1 or 2 opposite direction movement |
| P1855 | Shift fork 3 or 4 opposite direction movement |
| P1857 | Odd number gear axle interlock |
| P1858 | Even number gear axle interlock |
| P1859 | Disengagement too late with clutch 1 |
| P185A | Engagement too late with clutch 1 |
| P185B | Disengagement too late with clutch 2 |
| P185C | Engagement too late with clutch 2 |
| P185D | Clutch open not possible |
| P1862 | High side 1 system (Overcurrent) |
| P1863 | High side 1 system (Open circuit) |
| P1864 | High side 1 system (Short to power supply) |
| P1866 | High side 2 system (Overcurrent) |
| P1867 | High side 2 system (Open circuit) |
| P1868 | High side 2 system (Short to power supply) |
| P186A | High side 3 system (Overcurrent) |
| P186B | High side 3 system (Open circuit) |
| P186C | High side 3 system (Short to power supply) |
| P186D | High side 1 system (Voltage low range out) |
| P186E | High side 2 system (Voltage low range out) |
| P186F | High side 3 system (Voltage low range out) |
| P1870 | Engine torque signal abnormality |
| P1871 | APS system (Signal abnormality) |
| P1872 | Between shift lever and TC-SST system (Q-A function abnormality) |
| P1873 | Clutch 1 system (Pressure abnormality) |
| P1874 | Clutch 2 system (Pressure abnormality) |
| P1875 | Damper speed sensor system (Poor performance) |
| P1876 | Gear block 1st |
| P1877 | Gear block 2nd |
| P1878 | Gear block 3rd |
| P1879 | Gear block 4th |
| P187A | Gear block 5th |
| P187B | Gear block 6th |
| P187C | Gear block reverse |
| P1880 | EOL Mode Active |
| P1881 | Twin clutch SST control mode switch system (Malfunction) |
| P2718 | Clutch/shift pressure solenoid 1 system (Open circuit) |
| P2719 | Clutch/shift pressure solenoid 1 system (Overcurrent) |
| P2720 | Clutch/shift pressure solenoid 1 system (Short to ground) |
| P2721 | Clutch/shift pressure solenoid 1 system (Short to power supply) |
| P2727 | Clutch/shift pressure solenoid 2 system (Open circuit) |
| P2728 | Clutch/shift pressure solenoid 2 system (Overcurrent) |
| P2729 | Clutch/shift pressure solenoid 2 system (Short to ground) |
| P2730 | Clutch/shift pressure solenoid 2 system (Short to power supply) |
| P2733 | Clutch/shift switching solenoid 1, spool stuck |
| P2736 | Clutch/shift switching solenoid 1 system (Open circuit) |
| P2738 | Clutch/shift switching solenoid 1 system (Short to ground) |
| P2739 | Clutch/shift switching solenoid 1 system (Short to power supply) |
| P2741 | Fluid temperature sensor system (Gradient error) |
| P2742 | Fluid temperature sensor system (Output low range out) |
| P2743 | Fluid temperature sensor system (Output high range out) |
| P2766 | Input shaft 2 (even number gear axle) speed sensor system (Poor performance) |
| P2809 | Clutch/shift switching solenoid 2, spool stuck |
| P2812 | Clutch/shift switching solenoid 2 system (Open circuit) |
| P2814 | Clutch/shift switching solenoid 2 system (Short to ground) |
| P2815 | Clutch/shift switching solenoid 2 system (Short to power supply) |
| U0001 | BUS off |
| U0100 | Engine time-out error |
| U0103 | Shift lever time-out error |
| U0121 | ASC time-out error |
| U0136 | AWC time-out error |
| U0141 | ETACS time-out error |