Symptom Chart
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During diagnosis, a DTC associated with other system may be set when the ignition switch is turned ON with connector(s) disconnected. On completion, confirm all systems for diagnostic trouble code(s). If diagnostic trouble code(s) are set, erase them all.
SYMPTOM CHART
| Symptom | Inspection procedure No. |
|---|---|
| The scan tool cannot communicate with the shift lever-ECU. | INSPECTION PROCEDURE 1: THE SCAN TOOL CANNOT COMMUNICATE WITH THE SHIFT LEVER-ECU |
| Shift indicator light does not illuminate. | INSPECTION PROCEDURE 2: SHIFT INDICATOR LIGHT DOES NOT ILLUMINATE |
| Back-up light does not illuminate. | INSPECTION PROCEDURE 3: BACK-UP LIGHT DOES NOT ILLUMINATE |
| The driving mode cannot be changed. | INSPECTION PROCEDURE 4: THE DRIVING MODE CANNOT BE CHANGED |
| Speed change with the paddle shift is impossible. | INSPECTION PROCEDURE 5: SPEED CHANGE WITH THE PADDLE SHIFT IS IMPOSSIBLE |
| Shift lever-ECU power supply circuit abnormality | INSPECTION PROCEDURE 6: SHIFT LEVER-ECU POWER SUPPLY CIRCUIT ABNORMALITY |